110
111
Owner’s Manual
Single Mileage Reset
a. Press the MODE button and the (-) button together the single mileage is
Reset.
Switch from Single Mileage to Total Mileage
a. In the power-on state, press the MODE button to switch single /total
mileage.
Backlight
Brightness Setting
Interface
Cruise Control
Mode Setting
Interface
3. Backlight Brightness Setting
a. Press MODE to enter the
Backlight Brightness setting.
b. Press the (+) button to increase
the brightness and the (-) button
to decrease the brightness.
Setting range: 1-8.
ADVANCED SETTINGS
Cruise Control Mode
a. Press (-) button for 2 seconds
to enter the cruise mode
b. To deactivate, simply press one
brake lever
Note: When the wheel speed reaches or exceeds the set value, the motor’s output
power will continue to attenuate. The maximum speed is 32 km/h.
The LCD Panel has a special and integrated button, which consists of
three single buttons fixed on the left side of the LCD Panel.
1. Press the
MODE button for 2 seconds to startup
2. In the startup mode, press MODE button for another 2 seconds
to shut down
Note: If more than four hours without the use of your Velec, please take off the battery
from the Electric Bicycle and placed it in a dry storage.
MODE Button
General Setting
Interface
Speed Limit
Setting Interface
(+) Bouton
(-) Bouton
GENERAL SETTINGS
1. Km or Mile
a. Press the (+) button and the (-)
button together for 2 seconds
b. Press (+) button or the (-) but-
ton to switch from km / mile
2. Speed Limit
a. Press MODE to enter the speed
limit setting
b. Press the (+) button to increase
the limit and the (-) button to dec-
rease the limit
Setting range: 15-50Km/h;
10-32Mile/h
To Next Page
Loading...
Need help?
General
