To Next PageTo Next Page
Need help?Do you have a question about the Velleman-Kit K8200 and is the answer not in the manual?
General| Build Volume | 200 x 200 x 200 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Software | Repetier-Host, Cura |
| Heated Bed | Yes |
| Bed Temperature | Up to 100 °C |
| Nozzle Temperature | Up to 250 °C |
| Print Speed | 100 mm/s |
| Supported Materials | PLA, ABS |
| Technology | FDM |
The K8200 is a DIY 3D printer kit. Compliance depends on build quality and notes must be taken into account.
The power supply is CE-marked, protected against overload/short circuit. The printer operates at 15Vdc (extra low voltage).
EMC issues are related to the power supply and build quality. Shielding may be required; compliance with EN50081 normation is expected.
The printer head can reach up to 270°C and the heated bed up to 60°C. Use common sense and let the printer cool before maintenance.
Use PLA (safe/non-toxic) or ABS filament. ABS printing may cause irritation. Use in well-ventilated area, consider fume extraction for ABS.
The printer is not for unsupervised use by persons with reduced capabilities. Children must be supervised. This guide is for information only.
Provides detailed, step-by-step instructions for assembling the 3D printer. Includes a web link for access.
Details and specifications for the 3D printer are available online. Includes a web link for more information.
Access downloads, product support, and community forums via the provided web link.
