HQSA1024/HQSA1025/HQSA1026
V. 02 – 03/01/2019 3 ©Velleman nv
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as
unsorted municipal waste; it should be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service. Respect
the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before bringing
this device into service. If the device was damaged in transit, do not install or use it and
contact your dealer.
2. Safety Instructions
Read and understand this manual and all safety signs before using this appliance.
CAUTION – Risk of electric shock. Do not open.
CAUTION – To prevent possible hearing damage, avoid listening at high volume levels
for long periods.
CAUTION – Danger of explosion if the battery is replaced incorrectly. Replace only with
the same or equivalent type.
This device can be used by children aged from 8 years and above, and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the use of
the device in a safe way and understand the hazards involved. Children shall not
play with the device. Cleaning and user maintenance shall not be made by children
without supervision.
Always connect the device to a grounded circuit to avoid risk of electrocution.
Always disconnect mains power when the device is not in use or when servicing or
maintenance activities are performed. Handle the power cord by the plug only.
If the external flexible cable or cord of this device is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard.
All cords and cables should be routed so that they will not be walked on or pinched
by items placed upon or against them. Pay particular attention to the point where
they exit the unit.
To Next Page
Loading...
Need help?
General
