KNS4 VELLEMAN 1
KNS4 – COPTERMECH
1. Introduction & Characteristics
Thank you for buying the KNS4 ! Read this manual carefully before bringing the device into use.
•
Familiarise yourself with the operation of transmissions steered through gears or pulleys.
• Easy to build, no glue or soldering required.
• Dislodge the pre-cut pieces when you need them and not before. Sand the jagged edges before use (sandpaper
included)
•
The kit is powered by 2 AA-batteries (not included).
The kits of the KNS-series are supplied with prepunched boards, a gearbox, gears, shafts, a switch, a motor, a
battery holder and all necessary parts.
Note that the figures with the assembly instructions can be found in the second folder “KNS4 – Figures”!!!
2. Parts List
Part n° Quant. Description Part n° Quant. Description
1 1 motor holder 12 2 fixing plate
2 1 battery holder 13 3 PVC tube (1.5 x 15mm)
3 1 motor with wire 14 3 metal shaft (2 x 90mm)
4 1 slide switch with wire 15 3 metal shaft (2 x 70mm)
5 1 plastic tube (L : 15cm) 16 1 belt (black) (126 x 1mm)
6 1 metal shaft (2 x 40mm) 17 1 rubber band (35mm, red)
7 1 pinion gear 18 4 rubber band (40mm red)
8 1 face gear 36T/14T (white) 19 7 fixing plate (L-shaped)
9 2 pulley 19.5 x 2mm (blue) 20 15 nylon pad
10 8 pulley 15 x 2mm (yellow) 21 11 nylon pad
11 2 pulley 24 x 2mm (white) 22 26 self-tapping screw
3. Prepunched Boards (see “KNS4 – Figures
”
)
4. Assembly (see also “KNS4 – Figures
”
)
Fig. 4 : Insert part n°20 in the hole on board n°2 and mount the motor holder according to fig. 4.
Fig. 5 : Insert part n°20 (x 8) in boards n°1 & 4. Insert part n°7 between boards 1 & 4. Insert 2 x part n°15 in board
n°4 and through the pulley (part n°10). The metal shafts come out the other side of board n°1. Remember
to put the rubber bands (parts n°18 & 16) on the pulley before inserting the metal shaft. Another part n°15
goes through boards n°1 & 4.
Fig. 6 : Cut part n°5 to precisely 32mm. Insert part n°20 in board n°5 first, then put metal shaft n°14 through board
n°5. Mount part n°5 & 8 according to figure 6. Attach board n°5 to boards n°1 & 4 with part n°19.
To Next Page
Need help?
General
