VTTEST11 1 VELLEMAN
VTTEST11 – CABLE DETECTOR / TESTER
1. Introduction & Features
Thank you for buying the VTTEST11! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, do not use it and contact your dealer.
The VTTEST11 allows you to test and detect wiring and determine RJ12 connector polarity.
2. Contents
a. Tone Generator (A)
1. Test wires (2)
2. Test RJ12 plug
3. Mode switch
4. Low voltage indicator LED
5. Signal indicator LED
6. Audio signal switch
b. Cable Tracer Probe (B)
7. Test tip
8. Signal indicator LED
9. Low voltage indicator LED
10. Trace button
11. Volume control (on the side)
12. Mode switch (on the side)
13. Loudspeaker (at the back)
3. Technical Specifications
a. Tone Generator
Operating voltage 9Vdc ±15%
Operating current 10mA (tone) ; 20mA (cont)
Size (LxWxH) 115 x 62 x 27mm
Weight ± 130g
Square wave output ± 10Vpp
1. Single audio frequency ± 900Hz
2. Dual audio frequency ± 900-1000Hz
b. Cable Tracer Probe
Operating voltage 9Vdc ±15%
Operating current 25mA (L)
80mA (SP @ max. volume)
100mA (S&L @ max. volume)
Size (LxWxH) 205 x 40 x 38mm
Weight ± 80g
Max. reception sensitivity >30mV
Max. output volume ± 120dB
To Next Page
Need help?
General
Weight and Dimensions
