9
Rigging the fixture
Caution: Fixture may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do not install the moving head!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the fixture’s
weight.
When installing the device, make sure there is no highly inflammable material (decoration articles, etc.) in a
distance of min. 1.0 m.
CAUTION! Use an appropriate clamp to ring the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly! Ensure that the structure (truss) to which you are attaching the
fixtures is secure.
Securing the fixture via one safety wire Securing the fixture via two safety wires
Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried out
periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue, dust,
dew).
Unit not respond to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is “hot”; on some
other DMX devices pin 5 may be ‘hot’). Also, check that all cables are connected to the right connectors;
it does matter which way the inputs and outputs are connected.
To Next Page
Loading...