Velux INTEGRA KLI 311 User Manual

P
1 sec
1
2 3
4
6
max 3 sec
5
VELUX
®
2
ENGLISH
Setup of wall switch KLI 313 to operate
VELUX INTEGRA
®
solar awning blind MSL
If a non-functional wall switch must be replaced or if the wall switch cannot find certain products, the products can be
prepared for registration by resetting them manually.
Note: Reset products cannot be operated until they have been registered in the wall switch again.
Important: This only applies to KLI 313.
1
Remove plastic cover.
6
Replace plastic cover.
The awning blind can now be operated with the wall switch.
Note: The motor must be adjusted to the size of the window before full operation
of the awning blind begins. The adjustment will take place automatically the first
time the awning blind is operated. Before the awning blind runs to the preferred
position, it runs all the way up and down. Do not interrupt the adjustment!
2
Set switch to position I.
3
Press button P briefly.
Note: Registration (
4
and
5
) must
now be completed within the next
10 minutes.
4
Press PAIR button on the wall
switch for 1 second.
5
Press the STOP key and then the
DOWN key within 3 seconds.

Velux INTEGRA KLI 311 Specifications

General

Brand	Velux
Model	INTEGRA KLI 311
Category	Switch
Language	English