8 VELUX VELUX 9
English English
Before you can operate your VELUX
products, they must be registered
in the control pad.
Remove the battery lid by pressing
the button with a screw driver as
shown in the illustration
1
,
2
.
Insert batteries (type AA/LR6)
3
.
Choose language by rolling the
wheel ie by swiping a finger over
the display in the directions of the
arrows
1
.
Tap
2
.
Follow the directions in the display
and tap
when you are ready.
If all the products have been found,
tap
.
Note: Tap "Search again" if the
control pad does not find all the
products, and follow the instruc-
tions in the display. Go to the
section If the initial set-up fails, if
the control pad still has not found
all the products even if they are
connected to power.
Tap "OK".
Getting started
Initial set-up
Getting started
Initial set-up
1
2
3
1
2 5
4
3
1
2
To Next Page
Loading...
