EasyManuals Logo

Venmar AVS Constructo 1.0 HRV User Manual

Venmar AVS Constructo 1.0 HRV
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
3. MAINTENANCE
Risk of electric shock. Before performing any maintenance or servicing, always
disconnect the unit from its power source. When cleaning the unit, it is recommended
to wear safety glasses and gloves.
WARNING
!
Since this guide covers both HRV and ERV units, top and side ports, the illustrations shown
in the maintenance procedures are typical.
The following procedures applies for both HRV and ERV units.
Refer to pictures below to identify the inner parts of your unit.
VB0078
HRV core Foam filter brackets
Core retainers Core foam filters
ERV core Foam filter brackets
Core retainers Core foam filters
VB0077
3.1 QUARTERLY MAINTENANCE
Unplug the unit.
VD0005
Be careful while opening the door; water or small debris could fall out. For
HRV units, always wait one minute after disconnecting the unit before opening
the door in order to allow water to drain out from the unit.
WARNING
!
Unlatch the door and open it. Clean the inner side
of the door with a damp cloth, then wipe with a
dry one. Disengage the door from its hinge by sliding
it from left to right and set aside.
VD0179

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Venmar AVS Constructo 1.0 HRV and is the answer not in the manual?

Venmar AVS Constructo 1.0 HRV Specifications

General IconGeneral
BrandVenmar
ModelAVS Constructo 1.0 HRV
CategoryTest Equipment
LanguageEnglish