Need help?Do you have a question about the Venmar Solo 1.5 and is the answer not in the manual?
General| Airflow Capacity | 150 CFM |
|---|---|
| Type | Heat Recovery Ventilator (HRV) |
| Voltage | 120 V |
| Power Consumption | 60 W |
| Filter Type | Washable foam filter |
| Duct Size | 6 inches |
Exploded view illustrating components of the ventilation unit for service purposes.
Detailed list of replacement parts with corresponding model numbers and part codes.
Contact information and hours for technical assistance regarding the ventilation system.
Details on calculating ventilation needs using CSA F326 and Canadian Building Code standards.
Guidance on determining ventilation requirements based on ASHRAE Standard 62-2001.
Guidance for Zone A, recommending the Solo unit and setting 'extended defrost'.
Guidance for Zone B, recommending Solo or oversized Duo with 'extended defrost'.
Guidance for Zone C, recommending Solo or Duo units with pre-set defrost strategy.
Diagrams illustrating airflow paths for Solo and Duo units during normal operation.
Diagrams showing airflow during defrost or filtration modes for Solo and Duo units.
Ventilation and energy performance data for Solo 1.5 and Solo 2.0 models.
Ventilation and energy performance data for Duo 1.2 and Duo 1.4 models.
Ventilation and energy performance data for the Duo 1.9 model.
Diagrams showing the physical dimensions of the ventilation units.
Details on available main controls, optional controls, and system link options.
Table of key specifications including weight, port diameter, electrical supply, and power consumption.
Description and diagram for installing the unit in a fully ducted system.
Description and diagram for installing the unit in an exhaust ducted system.
Description and diagram for installing the unit using simplified volume ventilation.
Guidelines for choosing a location and securely mounting the ventilation unit.
Instructions and considerations for planning the ductwork layout for optimal airflow.
Methodology and tables for determining the correct duct diameters for airflow.
Instructions for installing ductwork and registers for various system types.
Instructions for installing stale air exhaust and fresh air distribution ductwork for fully ducted systems.
Instructions for installing ductwork for exhaust ducted (source point ventilation) systems.
Instructions for connecting ducts for simplified volume ventilation installations.
Detailed procedure for connecting insulated flexible and rigid ducts to the unit ports.
Guidelines for selecting appropriate locations and installing exterior intake and exhaust hoods.
Step-by-step instructions for connecting the drain fitting and tubing for Solo models.
Description and comparison of Venta, Supra, and Ultima main control models and their functions.
Details on optional controls like push-button timers and dehumidistats.
Information on furnace interlock, Perfect Climate Comfort Center interface, and control upgrades.
Specifications and physical dimensions for the main control units.
Step-by-step instructions for installing the Venta, Supra, and Ultima main wall controls.
Instructions for installing the wireless receiver and push button, including programming.
Diagram and instructions for connecting optional controls to the main PC board.
Instructions for connecting the unit to the furnace for interlock operation.
Detailed wiring diagram for the SOLO 1.5 and SOLO 2.0 ventilation units.
Detailed wiring diagram for the DUO 1.2, DUO 1.4, and DUO 1.9 ventilation units.
Step-by-step instructions for balancing air flow using a magnehelic gauge and chart.
Procedure to verify functionality of Venta, Supra, and Ultima main controls in various scenarios.
Procedure to verify functionality of optional controls like push-button timers and dehumidistats.
To Next Page
