Venstar ACC-TSEN - User Manual

To Next Page

P/N 88-871 Rev.1

Connect to the Air Temperature Sensor as shown

ACC-TSENAir Temperature Sensor

Connect to the thermostat backplate as shown

Use 18 - 22 gauge 2 conductor unshielded thermostat wire. Wire length not to exceed 200 feet.

The Air Temperature Sensor measures indoor or outdoor air temperature with a range of -20 to 120 degrees F.

If used indoors as a remote temperature sensor, the sensor will read room temperature and send the

information to the thermostat. If used as an outdoor temperature sensor, the sensor may be used to provide

outdoor temperature information (which is not used to control heating or cooling). The Air Temperature

Sensor should be mounted out of direct sunlight and in a place that is protected from direct rain and snow.

Mounting the sensor under an eave of a roof or under an overhang of a building is recommended.

Air Temperature Sensor

DOWN

OUTDOOR

Thermostat Backplate

White +

Black -

White +

Black -

Need help?

Do you have a question about the Venstar ACC-TSEN and is the answer not in the manual?

Summary

Describes the sensor's capabilities, operating range, and recommended mounting locations.

Details wire specifications and illustrates connections to the thermostat backplate and sensor.

Provides a table correlating air temperature with sensor resistance values in Ohms.

Describes the sensor's capabilities, operating range, and recommended mounting locations.

Details wire specifications and illustrates connections to the thermostat backplate and sensor.

Provides a table correlating air temperature with sensor resistance values in Ohms.

General