To Next PageTo Next PageWhy is the CV Control Switched Off in my Vent-Axia Sentinel Kinetic B Fan?
If the CV Control of your Vent-Axia Fan is switched off, it could be due to trapped pressure tubes or faulty sensors. For assistance, contact the service provider and provide the fault code number.
Critical safety warnings and installation guidelines to prevent hazards.
Guide to connecting switches, sensors, and mains power to the unit.
Steps for safely connecting the unit to the mains power supply via a fused spur.
Initial power-on sequence, control unit display, and button functions.
Introduction to commissioning, including good practices and a pre-installation checklist.
Accessing and navigating the commissioning menus for unit settings.
Setting Boost, Normal, and Low airflow speeds for supply and extract fans.
Setting up proportional inputs for humidity, CO2, or temperature sensors.
Configuration of SW4 momentary switch and Vent-Wise sensor inputs.
Instructions for cleaning or replacing the unit's fan filters.
Periodic checks of unit components, motors, and condensate drain.
Methods for diagnosing unit faults using fault codes and a reference table.
General| Heat Recovery Efficiency | up to 92% |
|---|---|
| Duct Connection Diameter | 125mm |
| Mounting | Wall or floor |
| Voltage | 230V |
| Frequency | 50Hz |
| IP Rating | IPX4 |
| Type | MVHR (Mechanical Ventilation with Heat Recovery) |
| Airflow | Up to 400 m³/h |
| Control | Integral digital controller |
| Filter Type | G3/F5 |
