100 Series
Thermostatic and Rain Controller
Installation Guide
Tel: +44(0)1202 744958 Fax: +44(0)1202 733026
Email: info@vent.co.uk Web: www.vent.co.uk
Unit 16c & 16f, Chalwyn Industrial Estate, Poole, Dorset BH12 4PE
To enter ‘advanced’ setup set your unit to “AUTO”
mode then press and hold the AUTO/MAN plus
SET +/- buttons simultaneously for 5 seconds.
Your screen should now read..
ADV
SETUP
After a moment the screen will change to display
To Advance
Press SET +/-
Using SET+/- is how you scroll through the
available options and saves each stage of any
alteration.
Now press “SET +/-”. The screen will read..
To + a value
Press Open
The Open button is used to increase any value.
Press “SET +/-” again. The screen will read..
To – a value
Press Close
The Close button is used to decrease any value.
Press “SET +/-” again. The display will read..
Proceed to
ADV Setup
Now you can proceed to the advanced setup
options.
Press “SET +/-” again. The display will read..
Room Temp
is now XXc
‘XX’ being the current temperature in your room.
By using Open(+) and Close(-) you can calibrate
the display temperature.
Press “SET +/-” again. The display will read
Full open
Cycle 013sec
013sec is the amount of time for the motor to
operate and fully open - in most cases this default
setting is adequate. You can of course, alter this
setting for your actuator by pressing the Open(+)
and Close(-) buttons.
Press “SET +/-” again. The display will read..
Opening
Temp =22c
This relates to the temperature that the room must
reach before the actuator will operate.
You can alter this setting by pressing the Open(+)
and Close(-) buttons.
Press “SET +/-” again. The display will read..
Closing
Temp =18c
This relates to the temperature that the room must
fall to before the actuator will operate.
You can alter this setting by pressing the Open(+)
and Close(-) buttons.
Press “SET +/-” again. The display will read..
AUTO LOCK
MODE OFF
Using autolock is a security feature that prevents
the unit from being used without entering a
passcode rst. You can turn this on or off by
pressing the Open(+) and Close(-) buttons.
Press “SET +/-” again will take you back to
AUTO MODE
The unlock sequence is:
Button 2
[ AUTO/MAN ]
Button 1
[ OPEN ]
Button 3
[ SET +/- ]
Button 4
[ CLOSE ]
100 Series Advanced Operations Guide
The default settings of our 100 series controller are suited to most user applications. However, if
you need to make advanced alterations such as; Thermostat, Actuator and Lock Calibration, then
please use the following guide.
fv10/100t/22092010
To Next Page
Need help?
General