Vents-us PS Series User Manual

WALL VENT
PS SERIES
INSTALLATION
TOOLS REQUIRED
Screwdriver Pencil
Screws 4 pc for 3/16”
openings Dowel 4 pc for 1/4”
Drill
1 DRILL A CORE HOLE IN THE WALL 2 INSERT THE TELESCOPIC AIR DUCT
Ø D
Ø D
Outdoor
Indoor
A
min 3°
The air duct end must protrude from outside for the distance A
that enables installation of the outer ventilation hood or grille.
For details, please refer to the installation instruction for the
ventilation hood or the grille.
Install the air duct with the minimum slope 3° downwards
outside.
Fill the gaps between the air duct and the wall with mounting
foam.

Vents-us PS Series Specifications

General

Series	PS
Category	Fan
Material	Plastic
Housing Material	Plastic
Application	Ventilation
Protection Rating	IPX4
Voltage	230 V
Applications	ventilation

Summary

Wall Vent PS Series Installation

Tools Required for Installation

Lists the essential tools needed for installing the wall vent, including a drill, screwdriver, and pencil.

Drill Core Hole in Wall

Instruction to drill a core hole in the wall for the air duct installation.

Insert Telescopic Air Duct

Guidance on inserting the telescopic air duct with a slight downward slope for proper drainage.

Disassemble the Vent

Step detailing how to disassemble the wall vent unit.

Mark and Drill Fastening Holes

Instructions for marking and drilling holes for securing the vent using the inner grille.

Secure Wall Vent to Surface

Procedure for fixing the back side of the wall vent to the mounting surface with screws.

Install Air Flow Regulators and Filters

Steps for installing the rope air flow regulator, filter, slide lever, and front panel.

Control Air Volume

Guidance on controlling the supply air volume using the slide lever or rope regulator.

Install Outer Ventilation Hood or Grille

Final step to install the outer ventilation hood or grille onto the wall vent.