Processing the LOGON Function
This function is done at the start of the day or at the start of a shift, depending on the business practices conducted.
On left bottom hand of the terminal’s home screen, a downward pointing arrow is shown,
press the corresponding purple key. This is the first purple key under the terminal’s screen on
the left.
The option ‘Function’ is displayed.
Select the ‘F2’ key
The terminal prompts ‘Enter Function’
Enter ‘93’ then press the ‘ENTER’ key (Green key)
The terminal prompts ‘PASSWORD’
Enter the four (4) digit password, then press the ‘ENTER’ key (Green key)
The option ‘HYPERCOM’ is displayed, select the ‘F2’ key
The terminal then goes through a process of communicating and upon completion prompts
‘APPROVED’.
Note
1. The communication process prior to approval shows: Processing… → Approved
To Next Page
