6
1 Foot
10 Seconds
Sanitizing Wand Operation
To operate your Verilux
®
CleanWave
®
Portable Sanitizing Wand:
1. While holding the Wand with bulb facing down and away from skin or eyes,
press the large blue button for 3 seconds (green light will flash).
2. Begin sanitizing by holding the Wand as close as possible and no more
than one-half inch above the surface and move Wand slowly side to side
in a 12" (1 foot) area. UV-C effectiveness depends on direct exposure,
duration and intensity. Place the wand as close to the object as possible,
preferably within 1/2 inch. (see illustration below).
3. To turn the Wand off, press the blue button until the green light goes out.
4. Remove batteries when not in use to extend battery life.
Note: A safety switch will automatically turn off the Wand if the light source is
turned upward (it will go back on when the light source is once again turned
downward).
After 10 minutes of continuous operation the unit will shut down —
simply restart Wand if additional use is required.
Low Battery Indication
When the battery is low and needs replacing, the Wand will beep 10 times
and the LED will flash 10 times.
*Calculation based on eliminating 99.9% of Influenza A on standardized size items.
VH03-MAN-Rev40-001.indd 6 9/26/17 1:48 PM
To Next Page
Loading...
Need help?
General