FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING MANUAL
44/64
Vertex Standard Co., Ltd.
feature is enabled. The callsign field may contain up to 6 characters.
Here’s how to program the CW Identifier:
1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 11: CW WRT.
3. Press the [F/W] key momentarily to display any previously-stored callsign.
4. Press the [F/W] key again to clear any previous callsign.
5. Rotate the DIAL knob to select the first letter/number of your callsign, then press the
[F/W] key momentarily to save the first letter/number and move on to the next character.
6. Repeat the previous step, as many times as necessary, to complete your callsign. If you
make a mistake, press the [] key to move back to the previous letter/number’s slot,
then re-select the correct letter/number.
7. When you have finished entering your entire callsign and it contains less than 6
characters, press and hold in the [F/W] key for one second to confirm the callsign. (if you
callsign has exactly 6 characters, you do not need to press and hold in [F/W] in this
step).
8. Press the PTT switch to save the settings and exit to normal operation.
9. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode again.
10. Rotate the DIAL knob to select Set Mode Item 10: CWID.
11. Press the [F/W] key momentarily, then rotate the DIAL knob to set this Item to “TX ON”
(to enable the CW ID function).
12. Press the PTT switch to save the settings and exit to normal operation.
R.F. Says:
You may check your work by monitoring the entered callsign. To do this, repeat
steps 1- 7 above, then press the MONI switch.
DTMF Operation
The VX-120/170’s 16-button keypad allows easy DTMF dialing for Autopatch, repeater
control, or Internet-link access purposes. Besides numerical digits [0] through [9], the keypad
includes the [*] and [#] digits, plus the [A], [B], [C], and [D] tones often used for repeater
control.
Manual DTMF Tone Generation
You can generate DTMF tones during transmission manually.
1. Press the [F/W] key, then press the [9(DTMF)] key to disable the DTMF Autodialer, if
necessary. The “CODE” indication will appear in the display for a moment.
2. Press the PTT switch to begin transmission.
To Next Page
Loading...
Need help?
General
