FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING MANUAL
45/64
Vertex Standard Co., Ltd.
3. While transmitting, press the desired numbers on the keypad.
4. When you have sent all the digits desired, release the PTT switch.
DTMF Autodialer
Nine DTMF Autodial memories are provided, allowing you to store telephone numbers for
autopatch use. You can also store short autopatch or Internet-link access code streams so as
to avoid having to send them manually.
Here is the DTMF Autodial storage procedure:
1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 17: DT WRT.
3. Press the [F/W] key momentarily to enable adjustment of this Set Mode Item.
4. Rotate the DIAL knob to select the DTMF Memory register (“d1” ~ “d9”) into which you
wish to store this DTMF string.
5. Press the [F/W] key momentarily to begin DTMF Memory entry into the selected register.
6. Rotate the DIAL knob to select the first digit of the DTMF string. Selectable entries are 0
- 9, and A - F, with E and F representing DTMF “*” and “#” tones respectively.
7. Press the [F/W] key to accept the first digit and move to the next digit of the DTMF string.
8. Repeat steps 5 and 6 until you have completed the telephone number.
9. If you make a mistake, press the [] key to move back to the previous digit, then
re-select the correct number.
10. If the telephone number made up of numbers only, you may key in the telephone number
directly from the keypad.
11. Press and hold in the [F/W] key for one second to save the setting.
12. If you store other numbers, repeat steps 4- 10 above, using a different DTMF memory
register.
13. When all required DTMF memories are filled to your satisfaction, press the PTT switch to
save the settings and exit to normal operation
To send the telephone number:
1. Press the [F/W] key, then press the [9(DTMF)] key to activate the DTMF Autodialer. The
“MEM” indication display will appear in the display for a moment.
2. While the DTMF Autodialer is activated, first press the PTT switch, then press the
numerical key ([1] through [9]) corresponding to the DTMF memory string you wish to
send. Once the string begins, you may release the PTT switch, as the transmitter will be
held “on the air” until the DTMF string is completed.
3. To disable the DTMF Autodialer, press [F/W] [9(DTMF)] again. The “CODE” indication
To Next Page
Loading...
Need help?
General
