Powering On the Cellcorder
Quick Start Instructions
Operating Instructions
2.
The firmware version number appears.
1. Press and release the green Power Key.
3. If readings are in temporary storage, messages
appear.
4. To save readings, insert the USB flash drive
and press Yes/F1. Whether you select Yes or
No/F2, readings stay in memory.
5. To clear readings from the memory, press
Yes/F1. Do this if you are starting a new set
of readings.
6. To keep readings in memory, press No/F2. Do
this if you are not finished taking readings or
want to examine the readings.
7. The Main Menu appears.
Note: It is highly recommended that the calibration
constants are saved to the USB flash drive.
Power
CRT-400 Cell Resistance Tester
™
Vertiv Corporation
1050 Dearborn Drive,
Columbus, OH 43065 USA
Telephone: (954) 337-7101
Fax: (954) 377-7042
Email: alber-service@vertivco.com
©2018 Vertiv Corporation
590-2093-501A /SL-29408/4200-049 R3
To Next Page
Need help?
General
