Vertiv Avocent ACS6000 Command Reference Guide

--:- language cli-> show
appliance_languate = english
--:- / cli->
2.1.17 wiz
Configures the IP parameters for the Eth0 interface. Shows the current configuration and asks for new
values for the following parameters:
• Status of the interface (enabled or disabled)
• IPv4 method (dhcp or static)
• IPv6 method (dhcp or static)
• IP address, mask and gateway (if static is chosen for either of the previous parameters)
• DNS Primary Server, Secondary Server, Domain Name and Hostname
• Enable or disable IPv6 support
After setting all parameters, confirm that all parameters are correct to save them.
2.1.18 connect
Connect to a serial port.
Syntax:
--:- access cli-> connect <port_name>
Example:
--:- access cli-> connect 77-77-70-p-2
-or-
(Optional) From the default directory:
--:- / cli-> connect access/77-77-70-p-2
Displays the following:
Password:
-or-
Type the hotkey to suspend the connection:
Ctrl + z
Vertiv | Avocent® ACS6000 Advanced Console Server Command Reference Guide | 13

Vertiv Avocent ACS6000 Specifications

General

Brand	Vertiv
Model	Avocent ACS6000
Category	Server
Language	English