Need help?Do you have a question about the VES Compas Fire Alarm Control Panel and is the answer not in the manual?
Steps and considerations for preparing the Compas Fire Alarm Control Panel before installation.
Instructions for securely mounting the fire alarm control panel to a wall or surface.
Details on installing the 5.25 Amp or 10.25 Amp power supply units.
Procedures for connecting the required 12VDC standby batteries for backup power.
Comprehensive tests to verify panel functionality, wiring, and configuration after installation.
Description and connection details for Notification Appliance Circuits and Auxiliary 24V terminals.
Illustration and location of slots for installing various panel modules on the main back board.
Mapping of panel module slots to specific field terminal locations for proper connection.
Overview of power supply features like deep discharge prevention and battery backup.
Configuration settings for the 5.25 Amp and 10.25 Amp power supplies via DIP switches.
Procedures for battery maintenance, inspection, load testing, and replacement.
Guidance on locating and replacing power supply and battery lead fuses.
Technical specifications for electrical inputs, AC input ratings, and voltage.
Detailed specifications for power supply fuses, output ratings, and battery ratings.
Electrical ratings for Hochiki and Apollo Protocol SLC loops, including voltage and current.
Specifications for Notification Appliance Circuit outputs, including power range and current limits.
Guidelines for calculating allowable cable length and voltage drop for SLC loops.
Method for calculating the total current load for system power supply sizing.
Steps to calculate the required amp hour rating for standby batteries.
General| Brand | VES |
|---|---|
| Model | Compas Fire Alarm Control Panel |
| Category | Control Panel |
| Language | English |
To Next Page