To Next PageTo Next PageWhy is the water not hot enough in my Vesta VRC-120 Boiler?
If the water isn't hot enough with your Vesta Boiler, make sure that both the gas and cold water supply valves are fully open. Also, check to ensure that the water temperature setting is correct.
What to do if my Vesta Boiler attempts to ignite but fails?
If your Vesta Boiler attempts to ignite but fails, turn off the boiler and then turn it back on. Have your installing contractor check the gas supply pressure. Ensure the boiler is powered by 120 V-1 PH-60 Hz.
What to do if hot water is not produced when opening a faucet in my Vesta Boiler?
If hot water isn't produced when you open a faucet with your Vesta Boiler, ensure that the gas and water supply valves are fully open. Also, check the water inlet filter for any debris and verify the power status of the boiler.
What to do if no water is available when I open a faucet connected to my Vesta VRC-120 Boiler?
If no water is available when you open a faucet connected to your Vesta Boiler, first check if the cold water supply is cut off and open it. Also, check if the boiler or the pipes are frozen.
Why is the space heating side of my Vesta VRC-120 malfunctioning?
If the space heating side of your Vesta Boiler is malfunctioning, check the boiler’s temperature setting. Make sure the power is on, and plugged into the outlet with the correct voltage. Press the Power button and raise the setting temperature. Make sure the boiler is turned on.
Why is the water too hot from my Vesta Boiler?
If the water from your Vesta Boiler is too hot, ensure that the gas and cold water supply valves are fully open. If only a small amount of hot water is required, it is possible for the temperature to be higher than the temperature set on the front panel. Decrease the water temperature on the front panel. If the cold water supply passes through a solar preheating system, it passes for the delivered water temperature to be higher than the temperature set on the front panel.
Why is there a fluctuation in hot water temperature in my Vesta VRC-120?
If you notice a fluctuation in hot water temperature with your Vesta Boiler, clean the water inlet filter for debris.
Why does water take a long time to become hot after opening the hot water faucet of my Vesta VRC-120?
Even though the Vesta Boiler unit may be operating properly, the cold water contained in the piping will need to flow through the faucet before the hot water can reach the faucet. Wait for several minutes.
Steps to take if gas is smelled, including not lighting appliances or using phones, and contacting gas supplier or fire department.
Warns about the risk of severe burns from water over 125°F, especially for vulnerable individuals.
Covers warnings related to combustibles, stored gases, accessing internal components, venting, and gas shut-off procedures.
Details cautions regarding unintended use, unapproved parts, servicing, obstructions, and operation if damaged.
Guide to adjusting the desired temperature for space heating mode, including a danger warning.
Procedure for adjusting the domestic hot water temperature, with a caution about scalding.
Step-by-step instructions for draining the boiler for maintenance or freeze protection.
Table detailing common problems like no ignition, heating malfunctions, and no hot water, with causes and solutions.
A chart listing error codes, their causes, and recommended self-diagnosis or technical actions.
General
