Need help?Do you have a question about the VESTEL V Series and is the answer not in the manual?
Provides essential information for end-users during installation and initial use.
Outlines initial checks and troubleshooting steps for technicians.
Instructions for removing transport screws before initial operation.
Guidance on adjusting the machine's feet for stable installation.
How to clean filters in the water inlet hose and valve to ensure water flow.
Instructions for cleaning the pump filter to maintain pump performance and longevity.
Indicates a failure scenario related to the door lock.
Indicates a failure scenario related to low water pressure or lack of water.
Indicates a failure scenario related to pump issues or a dirty filter.
Indicates an overflow error.
Indicates a failure related to the heater or NTC sensor.
Indicates a motor blockage or tachometer error.
Indicates a configuration error.
Indicates a motor triac short circuit.
Indicates an out-of-voltage range error.
Specifies lock/unlock times, voltage, and current for the door lock.
Instructions on how to test the door lock component's resistance.
Lists voltage, current, power, frequency, and resistance of the drain pump.
Procedure for checking the drain pump's resistance value.
Provides a table of NTC resistance values at different temperatures.
Instructions for checking the EMI filter's resistance value.
Describes the three levels of the pressure switch and its connections.
Methods for testing the pressure switch functionality.
Specifies the heating element's type, voltage, power, and resistance.
Guidance on checking the heating element's resistance value.
Lists nominal voltage, power, frequency, rated flow, and pressure.
Instructions for checking the valve's water flow rate and bobbin resistance.
Identifies the terminals for rotor coil, stator coil, tacho, and earthing.
Guidance on checking motor tacho terminals using a multimeter.
To Next Page
General