Do you have a question about the VESTEL F4 Series and is the answer not in the manual?
Technical details for various washing machine models.
Information found on the product's identification label.
General guidance for positioning the appliance.
Step-by-step guide to remove transport screws.
Instructions on how to level the machine.
Details on connecting the power supply safely.
Procedures for connecting the water inlet.
Instructions for connecting the drain hose correctly.
Explanation of the detergent dispenser system.
Explanation of buttons, knobs, and display.
Details of all available wash cycles.
How to activate and use the child lock feature.
Steps to perform an automatic diagnostic test.
Instructions for running diagnostics in service mode.
Steps to remove the appliance's top panel.
Guide on how to take apart the door assembly.
Procedure for removing the tub bellows seal.
Steps to remove the detergent dispenser.
Instructions for removing the main control panel.
Guide on how to detach the front panel.
Steps to remove the detergent drawer housing.
How to remove power cable and parasite filter.
Procedure for removing the EPS component.
Steps to remove the door lock mechanism.
Guide on how to detach the pump motor.
Instructions for removing the front counterweight.
Steps to remove the heating element.
Second procedure for tub bellows seal removal.
Steps to remove transport screws.
Instructions for removing the upper counterweight.
Steps to remove the main washing group.
How to remove shock absorber pins.
Steps to remove the drive belt.
How to remove the driven pulley.
Steps to detach the motor.
How to remove the tub entrance with bellows hose.
Steps to remove the pressure switch hose group.
Instructions for removing the main tub.
Steps to remove the drum from the tub.
Technical data and checking procedure for the drain pump.
Technical data and checking procedure for the heater.
Technical data and checking procedure for the NTC.
Technical data and checking procedure for water valves.
Technical data and checking procedure for the EPS.
The main electrical schematic for the appliance.