To Next PageTo Next PageWhat to do if VEVOR 10L-V1 Industrial Electrical pump can't get the liquid out?
If the pump isn't pumping liquid, there are a couple of things to check: * Make sure the power cord is properly plugged in; if not, reconnect it. * The filter might be clogged. In that case, clean or replace the filter.
Why is the control panel light not on for my VEVOR Industrial Electrical?
If the control panel light isn't on, the power cord might not be plugged in properly. Reconnect the power cord to resolve this.
General| Brand | VEVOR |
|---|---|
| Model | 10L-V1 |
| Category | Industrial Electrical |
| Language | English |
Key reminders before using the product, including understanding warnings and precautions.
Guidelines for operating the machine in suitable dry, well-ventilated environments and avoiding hazards.
Precautions for using power supply, avoiding short circuits, and electrical hazards.
Instructions for regular cleaning, power disconnection, and handling malfunctions.
Steps to take in case of overheating, smoking, abnormal sounds, or personal safety emergencies.
Statement on VEVOR's responsibility regarding safety accidents due to improper use or operation.
Guide for assembling the filling machine, including installing the tray, brackets, nozzle, and pipes.
Instructions for cleaning the machine after use with a mild cleaning solution and water.
Overview of the control panel, including weight, set, counter, trigger displays, and function buttons.
Details on setting filling weights and trigger values using specific button sequences.
Explains how to operate the machine in manual and automatic modes with delay and auto-reset.
Method for storing and recalling up to four preset filling weights for quick selection.
Procedure to cancel or enable the automatic peeling function by restarting and using button combinations.
Instructions for advanced settings, flow rate regulation, and using the speed knob.
Guide to setting filling time and interval time, switching between weight and time-based filling.
Guidelines on machine care, stability, initial use, and proper storage in a dry, ventilated place.
Recommendations for cleaning after each use and regular replacement of consumable parts like hoses and nozzles.
Solutions for the product not working, focusing on potential internal pump dryness and adding water.
Troubleshooting steps for the pump not getting liquid out, checking power cord and filter.
Solutions for the control panel light not illuminating, primarily checking the power cord connection.
Information on the WEEE directive and proper disposal of the product and accessories as electronic waste.
