A. The engraver does not know where to engrave, so before you start
engraving, there is an important task which is positioning. We will
complete the positioning operation in three steps.
B. Select the "Move to Center" button, the laser will move to the center
of the pattern, and the engraving will be placed below the laser.
C. Click "light laser" button, the laser will emit a weak light, the laser
emits irradiation point is the center of the engraving pattern, based on
this, adjust the position of the engraved object!
7. Positioning
1 2
Step2： light laser
Step1： Move to Center
To Next Page
Loading...