load.Also, make sure that the magnetic control line is connected to the U and W
positions of the DPS output.
10. How should the magnet switch, overload, and breaker capacities be
selected?
When using the above products, it should be selected as twice the capacity of the
rated current of the motor.
11. The motor slows down and does not run smoothly.
Please check the load volume of the motor and use the load less than 85% (over
current phenomenon caused by overloading).
12. There's a lot of noise when the motor is running.
Check the DPS and motor capacity (The motor is noisy and generates heat when
using a DPS with a specification higher than the appropriate capacity)
13. The current of Motor output is too high and overheating occurs.
Please check if the motor capacity and DPS capacity are properly selected. e.g.
MY-PS-15 model:Used for 10HP motor MY-PS-20 model:Used for 15HP motor
14. Is DPS available for sunbeds, welders, ovens, and tenning machines.
You can use it after contacting our head office. However, it is slightly less efficient
than when used in motors.
Address：Baoshanqu Shuangchenglu 803long 11hao 1602A-1609shi Shanghai
Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122
Australia
Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place,
Rancho Cucamonga, CA 91730
Pooledas Group Ltd
Unit 5 Albert Edward House, The Pavilions
Preston, United Kingdom
SHUNSHUN GmbH
Römeräcker 9 Z2021, 76351
Linkenheim-Hochstetten, Germany
Made In China
To Next Page
Loading...
