Common error and elimination
Error Phenomena Solution
Paper cutting is
not even or the
cuting size is not
accurate
The cutting paper is
unperallel and has
large and has large
deviation
Remove the backguage
position offset and loosen
the fastening screw to adjust
the angle of pushing board.
The blade can not
reset or works up
and down
continusly
All the button is invalid
and can not control the
blade
1.The sensor
’
s position
moves or was damaged.
2.The main board has been
damaged
The window can't
display or display
wrong or can't
Power buttons are
invalid
Check display board,main
board of the electrical
equipment,and circuit parts
Digital-controlled
circuit damsged
Paper-pushing part
can't work
1. Check stepping
motor,driver
2. Check whether the circuit
of main board is damaged
Alarm for
displayingE-1
The button is invalid
and cutting action
stops
1. Check the flash
2. Check the control pamel
Alarm for
displayingE-2
Cut normally,but blade
can't return to the
original position
1. Check limit sensor on the
blade shelf
2. Check the control panel
Alarm for
displayingE-4
Press shelf return
abnormal
1.Check limit sensor on the
press shelf.
2. Check the main board
Alarm for
displayingE-5
Pressing is abnormal 1.Check pressing motor
code-wheel sensor.
2.Check the main board
Alarm for
displayingE-6
Cut normally,but paper
pusher pusher can't
limit and adjust
1.Check pressing motor
backward calibration sensor.
2.Cheek the main board
E-1: Photo-electric protection
E-2:error for cutter motor code-wheel sensor
E-4:6error for pressing upper limit sensor
E-5: error for pressing motor code-wheel sensor
E-6: error for reset sensor
To Next Page
Loading...