VEVOR EM4556 - Average, Weighted, Peak, and Maximum Modes; Switching Measurement Units

After each power-on, the tester is in Average mode by default. The
display shows the symbol " AVG " as an indicator. Short press the "
FUN " button to sequentially switch to Weighted mode ( the symbol
" WEIGHTED " is displayed ), Peak mode ( the symbol " PEAK " is
displayed ) and Maximum mode ( the symbol " MAX " is displayed
). The four modes are described as follows:
Average Mode: The display shows the real-time average value
of the current measurement.
Weighted Mode: The display shows the real-time weighted
average value of the current measurement.
Peak Mode: The display shows the peak value detected since
entering Peak mode.
Maximum Mode: The display shows the maximum value
measured since entering Maximum mode.
4. Average / Weighted / Peak / Maximum Mode
In any measurement mode, short press the " UNIT " button to
switch the temperature unit between °C and °F.
In magnetic field measurement mode, long press the " UNIT "
button to switch the magnetic field unit between mG and μT.
5. Unit Switch
●
●
●
●
● Magnetic field measurement mode
( The display shows the symbol " MAG ". )
● Radio frequency field measurement mode
( The display shows the symbol " RF ". )
- 10 -