VEVOR FF-Q901 - Maintenance

19
Too many leaks in plumbing
Seal and tighten plumbing
Holes in abrasive hose
Replace hose
Air filter on compressor plugged
Clean
Lack of air pressure:
Compressor too small
Use smaller nozzle
Supply valves not on full position
Open valves
Nozzle size too large
Use smaller size
Leaks in plumbing
Seal and tighten plumbing
Holes in abrasive hose
Replace hose
Air filter on compressor plugged
Clean filter
Urethane gasket worn or dirty
Clean or replace gasket
Lack of abrasive flow:
Blaster tank empty
Fill tank
Moisture in media
Dry media
Not enough air pressure
Check system
Abrasive hose kinked
Straighten hose
Debris in media
Clean or screen media
MAINTENANCE
WARNING!
Failure to observe the following before performing any maintenance could
cause serious injury or death from the sudden release of compressed air:
● Depressurize the blast machine.
● Disconnect power supply.
● Lockout and tag out the compressed air supply.
● Bleed the air supply line to the blast gun.
Immediate replacement of worn components is required.Failure to replace