IMPORTANT: Blades are very sharp; handle them with care. Ensure that the
hand-held blender is unplugged from the power outlet before installing or removing
attachments.
GETTING STARTED AND STOPPED
1. Check that the power button (3) is released.
2. Install the blending rod.
3. Connect the main unit to the power source.
4. Press the safety button (1) and proceed to the next step within 5s. If the
unlocking fails after 5s, press the safety button (1) again.
5. Press the power button (3) to start the hand blender (working time per cycle≤ 3
minutes, interval time between two cycles≥ 1 minute).
6. Release the power button (3), and the machine will stop automatically.
To Next Page
Loading...
