•Always unplug the power transformer from the electrical outlet before any
cleaning and handling.
•Indoor use only. Place the transformer away from fire, moisture & direct sunlight.
(Option for pump with light).
•Do not immerse hot glass tube cover into water or pour water directly on glass
tube surface when it is lighted.
•Glass tube cover is make of glass. It is fragile. Should handle with care during
light installation & light bulb maintenance. Wear gloves to protect your hands from
hurting if the glass is broken.
•The supply cord cannot be replaced. If the cord is damaged, the appliance should
be scrapped.
To keep water clean
•Periodically change water to prevent water from becoming sticky and forming
microorganisms.
Trouble Shooting
If the pump fails to run, the following should be checked:
•Check the circuit breaker, or try a different outlet to make sure that the pump is
getting electrical power. NOTE-Always disconnect the pump from electrical outlet
before checking.
•Check the pump discharge and tubing for kinks and obstructions.
•Algae buildup can be flushed out with a garden hose.
•Remove the pump filtering cover & pump chamber to access the impeller area.
Turn the rotor to ensure it is not broken or jammed.
With little flow rate, the pump will spew or "burp":
•Check the water level to make sure the pump is completely submerged.
If abnormal noise is heard during operation (with water):
•First disconnect the power supply and then remove pump filtering cover & pump
chamber.
•Use hand to grip the impeller, gently pull the impeller/rotor assembly out of the
pump housing.
•Rinse the impeller/rotor assembly and the cavity with clean water. If breakage or
surface damage is found on the assembly, contact your distributor for part
replacement.
Warning Ill
To Next Page
Loading...