To Next PageTo Next PageWhat to do if my VEVOR RWS16000 Water Dispenser doesn't soften water?
If your VEVOR Water Dispenser isn't softening water, first check the water quality using a test strip. If the water is hard, regeneration is needed.
Why is my VEVOR RWS16000 leaking from the inlet/outlet?
If your VEVOR Water Dispenser is leaking from the inlet or outlet, ensure the fittings are properly connected. If the leak persists, add a PTFE thread seal tape.
How to fix a leak on the cap/head of my VEVOR Water Dispenser?
To fix a leak on the cap or head of your VEVOR Water Dispenser: * Twist and tighten the cap/head properly. * If the leak continues, replace the o-ring.
Read and understand all instructions. Follow warnings and cautions. Use common sense. Ensure safe and responsible operation.
Keep work area clean, dry, and well-lit. Avoid fire/explosion risks, electrical contact, and keep children away.
Stay alert, use common sense, dress properly, wear PPE. Avoid distractions and hazardous clothing.
Use on hard-level surfaces. Do not alter the product. Keep away from children.
Connect water source, flush unit for 4-6 minutes until water is clear.
Connect water source to inlet, hose to outlet, and other end to RV/trailer.
Read and understand all instructions. Follow warnings and cautions. Use common sense. Ensure safe and responsible operation.
Keep work area clean, dry, and well-lit. Avoid fire/explosion risks, electrical contact, and keep children away.
Stay alert, use common sense, dress properly, wear PPE. Avoid distractions and hazardous clothing.
Use on hard-level surfaces. Do not alter the product. Keep away from children.
Connect water source, flush unit for 4-6 minutes until water is clear.
Connect water source to inlet, hose to outlet, and other end to RV/trailer.
General| Brand | VEVOR |
|---|---|
| Model | RWS16000 |
| Category | Water Dispenser |
| Language | English |
