Remark: 1. The upper screws must be fastened tight, the minimum
distances between screw head and wall is 3mm.
Remark: 2. The wall behind the heater is not allowed to be covered by
materials like asbestos cement, asbestos board and so on, because this
sort of covering layer could cause high temperature and a risk of burn.
Remark: 3. Must use qualified materials for the walls and ceiling.
SPECIFICATIONS
Above suggested heating time should be achieved, including but not
limited to these:
1. Room thermometer installed opposite to the sauna heater,closing to
the ceiling.
2. Sauna room is installed indoor with insulation for diffusion prevention
purpose.
3. Temp knob adjust to the Max.
To Next Page
Loading...
