Important note: Always check the integrity of the seal ring. If the seal ring is broken, it
should be replaced with a new one
Use the supplied Vaseline to lubricate the seal ring in the illustrated area.
Install the mixer shaft as shown; install the head of the mixer shaft (C) to the shaft (D)
Tips: Rotate it into the first half of the bowl and push the bowl to the designated position in
contact with the seal ring (B)
1) Align the head of the mixer shaft with the interface inside the bowl, press down the bowl,
and follow instructions below to reinstall the faucet.
2) Lubricate the joints fully with the supplied Vaseline
3) Put the piston in the designated position, and push the handle until it connects the
faucet.
6.7 Rinse cycle
Before starting the machine, it must be cleaned circularly
Proceed as follows:
1. Fill the bowl with water
2. Let the machine stir for 5 minutes
3. Turn off the machine, and open the tap to empty the water in the bowl
6.8 Clean the water box
The water box should be emptied and cleaned regularly
Pull up the water box with the lid and then pull it out
6.9 Lamp cover
6.9.1. Lamp replacement
When replacing the lamp, the main switch must be turned off and the power must be
disconnected.
Remove the protective cap and unscrew the cover screws; use suitable screwdriver to
operate
6.10 Regular maintenance
1) The machine must be maintained regularly by professional technicians (at least once a
year)
2) Regular inspection can ensure that all components are installed in place, and the
machine can run safely.
3) Any damaged components must be replaced with original parts
To Previous Page
Loading...
