Vex CORTEX - Page 6

CORTEX Microcontroller and Joystick Quick Start Guide
Page 6 of 9
a. The CORTEX may be reprogrammed. Shown is the interconnect sketch for wireless reprogramming. For non-wireless
reprogramming, the VEXnet keys may be substituted with a USB A-male to A-male cable.
Arcade Mode - Channel 1 (right stick, X-axis) + Channel 2 (right stick, Y-axis)
Arcade Mode - Channel 1 (right stick, X-axis) + Channel 2 (right stick, Y-axis)
Arcade Mode - Channel 1 (right stick, X-axis) + Channel 2 (right stick, Y-axis)
Channel 1 (right stick, X-axis)
Motor 1 LEFT DRIVE Joystick Right = Motor CW
Robot Turn Rate
Motor 2 LEFT DRIVE Joystick Right = Motor CW
Motor 3
LEFT DRIVE
Joystick Right = Motor CW
Motor 4 RIGHT DRIVE Joystick Right = Motor CW
Motor 5 RIGHT DRIVE Joystick Right = Motor CW
Motor 10 RIGHT DRIVE Joystick Right = Motor CW
Channel 2 (right stick, Y-axis)
Motor 1 LEFT DRIVE Joystick Up = Motor CW
Robot Forward Speed
Motor 2 LEFT DRIVE Joystick Up = Motor CW
Motor 3 LEFT DRIVE Joystick Up = Motor CW
Motor 4 RIGHT DRIVE Joystick Up = Motor CCW
Motor 5 RIGHT DRIVE Joystick Up = Motor CCW
Motor 10 RIGHT DRIVE Joystick Up = Motor CCW
Reverse Motor Direction
Reverse Motor 1 Jumper in Digital 1
Reverse Motor 2 Jumper in Digital 2
Reverse Motor 3 Jumper in Digital 3
Reverse Motor 4 Jumper in Digital 4
Reverse Motor 5 Jumper in Digital 5
Reverse Motor 6 Jumper in Digital 6
Reverse Motor 7 Jumper in Digital 7
Reverse Motor 8 Jumper in Digital 8
Reverse Motor 9 Jumper in Digital 9
Reverse Motor 10 Jumper in Digital 10
Limit Switch Inputs
Motor 6 ignores CCW Jumper in Analog 1
Motor 6 ignores CW Jumper in Analog 2
Motor 7 ignores CCW Jumper in Analog 3
Motor 7 ignores CW Jumper in Analog 4
Motor 8 ignores CCW Jumper in Analog 5
Motor 8 ignores CW Jumper in Analog 6
Motor 9 ignores CCW Jumper in Analog 7
Motor 9 ignores CW Jumper in Analog 8
276-2186
Programming
Cable
Program
Port
Microcontroller
Joystick
PC
USB Port