What to do if VIAIR Automobile Accessories compressor hooked up to system runs continuously?
If your VIAIR Automobile Accessories compressor runs continuously, it could be due to a defective pressure switch, in which case you should replace it. Alternatively, if your air tank setup includes a safety valve, inspect it for defects and replace it if necessary.
What to do if VIAIR 20052 compressor hooked up to system will not run?
If the VIAIR Automobile Accessories compressor isn't running, first, ensure the power wire is properly connected and the ON/OFF switch on the Dash Panel Gauge is in the ON position. Second, check the fuse amperage and replace the fuse if needed.
Why are my VIAIR 20052 air fittings leaking?
Air fittings on your VIAIR Automobile Accessories might be leaking due to loose connections or improperly installed air lines. Check the connections with a soap and water solution. Reapply sealant to the fitting and reassemble, being careful not to overtighten. Also, make sure the system pressure is released before making repairs. If the air line tubing isn't fully inserted or is not cut squarely, remove the air line, cut off one inch, and reinstall it.
How to fix VIAIR Automobile Accessories gauge leaks?
To fix gauge leaks in your VIAIR Automobile Accessories, first check if the gauge connection is loose. If so, remove the air line from the back of the gauge, cut off one inch, and reinstall it. Another cause could be that the air line isn't pushed in all the way or cut squarely. In this case, tighten the compression fitting collar.
Lists available VIAIR Onboard Air Hookup Kit part numbers and pressure ratings.
Details all individual parts included in the Onboard Air Hookup Kit with identification letters.
Checks compressor compatibility and provides initial installation context and warnings.
Comprehensive guide for physically installing the kit components and routing lines.
Explains how to use the Onboard Air Hookup Kit and its features like the dash panel gauge.
Provides solutions for common problems like air leaks and compressor not running.
Outlines the product warranty period, coverage, and how to claim service.
General| Product Type | Air Compressor |
|---|---|
| Maximum Pressure | 150 PSI |
| Power Source | 12V DC |
| Duty Cycle | 33% |
| Weight | 10.55 Lbs |
| Dimensions | 10.5 x 5.5 x 5.5 inches |
| Inlet Port Size | 1/4 inch NPT |
| Max Amperage | 30A |
To Next Page
