OP700 / OH850
OP700
OmniPAP CPAP SETUP
25
Note : Make sure the power adapter will not be pulled during your treatment.
Place the device on a stable surface beside the bed.
Connect the power adapter to the power supply connector at the rear end of
the device, and plug the power cord to the wall outlet.
Intended Use
Assemble your mask system according to the
mask user’s manual.
Connect your mask to one end of the air tubing.
Set up the Mask
Connect the other end of the air tubing to the
air outlet of the device.
To Next Page
Loading...
Need help?
General