OP700 / OH850
OH850
OmniPAP APAP SETUP
26
Note : Make sure the device is unplugged when you insert/remove the Integrated
Upgrading Component.
Connect the Integrated Upgrading Component to the extension port of the
device.
Set up the Integrated Upgrading Component
Note : Make sure the power adapter will not be pulled during your treatment.
Place the device on a stable surface beside the bed.
Connect the power adapter to the power supply connector at the rear end
of the device, and plug the power cord to the wall outlet.
Install the System
To Next Page
Loading...
Need help?
General