1
2 3
Step 3
Remove the rubber plug from
the back cover.
Insert the side hole of the display
into the stand positioning column.
Note: User can refer to the
triangle symbol on the back cover
for the position of the hole.
Lock the display with 4 screws.
Note: When locking the srews,
ensure to hold the display to
avoid the display dumping.
Spread the protective sheet in
the package on the flat ground
and put on the stand.
Install the three parts in the
middle.
Note: Pay attention to the
direction of the logo.
Install the stand on the other
side refer to graphic order.
Note: Pay attention to the
installation order.
1
2
3
Installing the Stand (Optional)
Step 1
Open the stand package.
Step 2
1. 2.
3.
4.
Make the stand standing.
Note: Ensure to hold the both
sides to prevent apart.
1.
Ensure the direction and position
of logo are consistent with figure
above. Rotate the tube to expose
the screw holes then install the
screws and plastic caps.
2.
Insert the four wheels.
3.
Thread the screws through the
stand and plastic sleeve.
4.
1.
2.
3.
Install the rubber plug.
Note: Pay attention to the
direction of the rubber plug.
4.
To Next Page
Need help?
General