9
End-of-Season Care and Storage
Follow the CLEANING instructions when the humidifier will not be used for at least one week, or it
is the end of the season. At the end of the season, remove any accessories used with the humidifier
and allow the humidifier and accesories to dry completely before storing.
DO NOT store with water inside the Base, Water Reservoir or Tank.
Pack unit safely and store in a cool, dry location.
Troubleshooting
If your humidifier is not working properly, refer to the following:
Problem Possible Cause Solution
Power button has been
pressed but the control
panel lights are off.
• Unit not plugged in
• No power at outlet
• Plug unit in
• Check home circuits, fuses;
test outlet
Power is on and little or
no mist is produced
• No water in tank
• Unit is not level
• Mineral deposits on Nebulizer
• Power setting may be too low
• Water Tank or Base were
washed with detergent
• Fill Water Tank with cool water
• Place on a level surface
• Clean Nebulizer (refer to
Weekly Cleaning instructions)
• Press the ‘up’ arrow to
increase output
• Rinse thoroughly with clean
water until there is no foam or
smell of cleaning solution
Water overflows
from Reservoir
• Tank may be damaged
• Tank Cap is not tight
• Tank Cap Seal may be missing
• Check the Tank for any cracks
or damage and replace if
necessary
• Close Tank Cap to lock position
• Check to see if Cap Seal is
attached to Tank Cap. If not,
contact Consumer Relations
Condensation forms
around humidifier or on
windows and walls
• Mist Intensity is set too high
for room size or
pre-existing humidity level
• Humidifer may be too close
to wall or window
• Decrease mist output to
lower setting or open door
to the room
• Move humidifier away from
wall or point Mist Outlet away
from wall or window
NOTE: Failure to keep this unit clean from mineral deposits normally contained in any water supply
will affect the efficiency of operation of this unit. Customer failure to follow these instructions may
void the warranty.
To Next Page
Loading...
Need help?
General
