To Next PageTo Next Page
Need help?Do you have a question about the Victor Pumps S Series and is the answer not in the manual?
Declares pump compliance with EU directives and lists harmonized standards applied.
Explains ATEX marking, group, category, protection, gas explosion class, temperature class, and EPL.
Details specific ATEX requirements for pumps, including seals, lubrication, earthing, and temperature limits.
Provides essential information for safe, adequate, and effective pump operation, reducing risks and costs.
Details the purpose of the manual and guidelines for pump personnel.
Details safety regulations, potential hazards, and precautions for pump operation, maintenance, and handling.
Instructions for inspecting pumps and parts upon arrival for any damage or discrepancies during transport.
Guidelines for proper storage of pumps, including packaging, location, and environmental protection measures.
Details the features and capabilities of the S series centrifugal self-priming pumps.
Outlines the manufacturer's warranty terms, conditions, exclusions, and validity for defects.
Provides detailed steps for installing pumps, including ATEX checks, connections, and electrical motor setup.
Guides pump installation, referencing ATEX requirements, pipework, and motor connections.
Guides the user through initial start-up procedures, including filling the pump casing and checking rotation.
Details procedures for starting and stopping the pump, including frequency limits and post-start checks.
Lists common operating problems such as pump not starting, low delivery, noise, and leaks.
Troubleshooting guide for insufficient pump delivery, covering causes like clogged filters or low speed.
Troubleshooting guide for pump noise, addressing causes like blocked pipes, cavitation, or worn bearings.
Troubleshooting guide for pump leaks, covering issues like loose screws, overpressure, or seal damage.
Outlines the inspection plan, lubrication of mechanical seals, and general maintenance tasks.
Details periodic checks for pump operation, noise, bearings, and mechanical seals.
Provides guidance on lubricating mechanical seals, noting types that require no lubrication.
Covers procedures for disassembling the pump, repair preparation, and post-repair steps.
Explains the description, installation, activation, and disposal of the automatic lubricator.
Details the description, assembly, and maintenance of the coupling for Bi-Block pumps.
Provides instructions for installing and connecting temperature sensors for pump monitoring.
Explains the function of the temperature sensor in monitoring fluid temperature and controlling the pump.
Guides the installation of the PT100 temperature sensor into the pump's drain plug.
Details sensor installation for magnetic drive pumps, including component parts and location.
Covers transmitter parameters, connection to reading units, and setting temperature limit values.
General| Type | Centrifugal Pump |
|---|---|
| Material | Cast Iron |
| Seal Type | Mechanical Seal |
| Frequency | 60Hz |
| Inlet/Outlet Size | 1 inch to 3 inches (varies by model) |
