Victory Motorcycles Vision Tour User Manual (English)

Questions and Answers:

M
Marissa MorrisAug 2, 2025
Why is it hard to shift gears or find neutral on my Victory Motorcycles Vision Tour?
- T
  Tara WongAug 2, 2025
  Difficulty shifting or finding neutral on your Victory Motorcycles Motorcycle can occur due to several reasons. It could be that the shift linkage bushings are dry or worn, so you should try lubricating the shift linkage. Other potential causes include incorrect engine oil level or the wrong type of oil, contaminated hydraulic clutch fluid (flush hydraulic clutch fluid), air in the hydraulic clutch system (bleed system), a loose clutch slave cylinder bracket (inspect/tighten loose parts), a hydraulic clutch fluid leak (inspect system for leaks) or clutch damage (replace clutch).
K
Kathy TaylorAug 10, 2025
What to do if the anti-lock brake light stays on in my Victory Motorcycles Vision Tour Motorcycle?
- T
  Thomas GutierrezAug 10, 2025
  If the anti-lock brake light remains illuminated or illuminates intermittently on your Victory Motorcycles Motorcycle, check the fuses first. Also, inspect the pulse ring for looseness or chipped teeth and check the wheel speed sensor and pulse ring for any debris. Inspect the wheel speed sensor for a cracked housing.
N
Nancy James PhDAug 17, 2025
Why is my Victory Motorcycles Motorcycle battery charging rate low, or why does the battery discharge?
- J
  John ManningAug 17, 2025
  A low battery charging rate or a battery that discharges on your Victory Motorcycles Motorcycle can be caused by several factors. Check and clean the battery cable connections and charging circuit connections. Also, the accessory load might exceed the charge rate, so use the ACC position and limit accessory operation when the engine is off. It also may be caused by an improperly wired accessory that is causing a current draw.
P
pkelleyAug 26, 2025
How to fix brake noise or poor brake performance on my Victory Motorcycles Vision Tour?
- L
  Laura BrownAug 26, 2025
  If you are experiencing brake noise or poor brake performance on your Victory Motorcycles Motorcycle, it could be due to dust or dirt on the brake disc(s), so try cleaning the disc. Another cause could be worn pads or a damaged brake disc, so inspect the pads. Also, inspect the brake fluid level and fluid, as a low level or contaminated fluid can cause issues.

Victory Motorcycles Vision Tour Specifications

General

Compression Ratio	9.4:1
Final Drive	Belt
Brakes	ABS
Engine Type	V-twin
Displacement	1731 cc
Bore x Stroke	101 mm x 108 mm
Fuel System	Electronic Fuel Injection
Cooling	Air/Oil-cooled
Horsepower	92 hp
Torque	109 ft-lb
Transmission	6-speed
Front Suspension	Telescopic fork
Rear Suspension	Single shock, adjustable
Front Brake	Dual disc
Rear Brake	Single disc
Front Tire	130/70R18
Rear Tire	180/60R16
Seat Height	26.5 in