Victory ROSE - Emptying the Whirlpool Bath

2.Tofillupthebath:
1.Removetheeasy-to-disassemblewoodenpartsofthebathhousingplacedonbothfront
sidesofthewhirlpoolbath.
2.Checkthepositionofthevalvesshutdownallvalves9,6,and8.Valves1,3,4,and7have
toremainopened.
3. Turnthepoweron.
Afterturningthepoweron,thewhirlpoolbathandthestillingbasinbegintofillup. Theprocess
offillingupcontinuestothepointwhentherightwaterlevelisreached. Tofullyenjoyfunctions
ofthebathmakesurethattherightwaterlevelhasbeenreached.
Inordertorefillanylossesofwaterthewatersupplyoughttobepermanently
connectedtothebath.Incaseofoverlylowwaterlevelthefiltration,thewaterheating
systemandalsotheanti-frostsystemdonotwork. Atlowlevelsanoverlylowwater
levelmayleadtobathdamages.
3.Emptyingthewhirlpoolbathandthestillingbasin.
Toemptythewhirlpoolbathusethesewerageconnectionatthefrontofthebath.
Inordertoemptythewhirlpoolbath,turnoffallappliancesandconnectthehosewiththe3/4”
endingtothedrainatthefrontofthebath.Removethewoodencomponentofthebathhousing
placeddirectlyabovetheconnection. Thisiswherethedrainingvalves9areplaced.Openthe
drainingvalves9. Afteropeningthevalvesthebathstartstoempty.
7
8
I
J
7 Thewatersupplyconectionacrosselectricvalve
8Directwatersupplyconnection
I-Electricvalve
J-Prefilter
UsevalveNo tomanualfillupthebathwhen
electricvalveisdamaged.
8
I
Filling:valve7-open
9
9
9
9
Emptyingofthebathandbasin
allvalves9-opened
The3/4”watersupplyconnection
Sewageterminal3/4”