Need help?Do you have a question about the Victron energy Digital Multi Control and is the answer not in the manual?
General| Brand | Victron energy |
|---|---|
| Model | Digital Multi Control |
| Category | Control Panel |
| Language | English |
Setup for VE.Bus systems with one AC source. Adapt current limit if needed.
Details on building VE.Bus systems with two AC sources.
Shore current limit set by knob. Generator current set during installation. Special PowerAssist features.
Step-by-step guide to enter configuration mode, change parameters using knob and button.
Scaling factor calculation for non VE.Bus Multis to match DMC to system currents.
Parameter for external transfer switch to set generator current limit.
To Next Page
