Need help?Do you have a question about the Victure HC-300 and is the answer not in the manual?
Explains the function, type, range, and button layout of the infrared wireless remote control.
Instructions on how to navigate menus and select options using the remote control buttons (Up, Down, Left, Right, OK).
Details how the camera sends pictures instantly via GPRS network and the necessary MMS settings.
Guidance on inserting the SD card and SIM card correctly, noting write-protect switch and angle.
Steps to power on the camera, enter ON mode, and understand the buffering time and automatic capture.
Explains how to switch to TEST mode for custom settings, manual capture, preview, and sending MMS.
How to access the camera settings menu in TEST mode via the MENU button on the remote control.
Procedure for formatting the SD card, warning that all data will be deleted.
Defines the PIR disable time after triggering, from 5 seconds to 30 minutes.
Adjusts the PIR sensor sensitivity (High, Normal, Low) for optimal motion detection.
Instructions for configuring MMS parameters by editing a 'gsm_info.txt' file on an SD card.
Enables and sets a password for camera access, prompting for entry on startup.
Steps for upgrading the camera's firmware using an SD card and update file.
Explains the function, type, range, and button layout of the infrared wireless remote control.
Instructions on how to navigate menus and select options using the remote control buttons (Up, Down, Left, Right, OK).
Details how the camera sends pictures instantly via GPRS network and the necessary MMS settings.
Guidance on inserting the SD card and SIM card correctly, noting write-protect switch and angle.
Steps to power on the camera, enter ON mode, and understand the buffering time and automatic capture.
Explains how to switch to TEST mode for custom settings, manual capture, preview, and sending MMS.
How to access the camera settings menu in TEST mode via the MENU button on the remote control.
Procedure for formatting the SD card, warning that all data will be deleted.
Defines the PIR disable time after triggering, from 5 seconds to 30 minutes.
Adjusts the PIR sensor sensitivity (High, Normal, Low) for optimal motion detection.
Instructions for configuring MMS parameters by editing a 'gsm_info.txt' file on an SD card.
Enables and sets a password for camera access, prompting for entry on startup.
Steps for upgrading the camera's firmware using an SD card and update file.
General| Video Resolution | 1080P |
|---|---|
| Detection Range | 20m |
| IR Flash Range | 20m |
| Memory Card Support | up to 32GB |
| Power Supply | 4 x AA batteries |
| Waterproof | IP66 |
| Night Vision | Yes |
To Next Page
