2.5” (65mm)
Fig. 3d
Fig. 3e
Step 5: Hang the television display
9
1. Place the Wall Mount (1) flat against the wall in the desired location. Use the wall plate as a
template to mark the location of the four mounting holes on the wall. Make sure that the mounting
holes are level and parallel. Make sure the horizontal holes are no closer than 16”.
2. Use 3/8” (10mm) drill bit to pre-drill four holes at least 2.5” (65mm) deep (Fig 3d) at the
marked locations.
3. Insert a Wall Anchor (B) into each pre-drilled hole and lightly tap it with a hammer until the wall
anchor is flush with the wall.
4. Use a wrench, the four Long Bolts (A), and Washers (C) to attach the wall mount to the wall with
the Wall Anchors (B) (Fig 3f).
5. Use the Level (R) placed on the front of the mounting plate to level the wall mount, repositioning as
necessary, then securely tighten the bolts.
C
Fig.3f
Concrete wall
C
A
A
B
A large television requires two people to lift. Schoenfeld International Inc. and VIDAO are not
responsible for equipment damage or personal injury due to mishandling.
R
To Next Page
Loading...