31
SETUP DESIGN PARAMETERS
Mode Parameter Data Description
IR Select This is remote option as per model design data
SETUP
Clear
EEPROM
By doing Clear EEPROM, all design parameters get
reset to default values
Keyboard
Select
5 Keys /
7 Keys
This is to select TV keys 05 keys or 07 keys – Model
dependent.
Burning Off
If make ON, then Red/Green/Blue screen flash.
Used for production only.
Power
Status
Off
Parameter for default condition after mains ON i.e.
set will go to stand by of directly ON.
Boot Logo OFF Not Applicable.
LED
Blinking
OFF
Make ON then LED will blink with each remote
pulse. If make OFF then LED will be OFF when TV
is ON.
Source
Switch
TV/AV1/AV2/
YPbPr/d2h/
HDMI/ MM
Source selection. This is as per model design data.
M-Mode Off To make On/Off Manufacturing Mode.
Clone
Clone Out
Data
To create E2P from design data to USB.
Clone Out
Into
To load E2P in Set from USB.
CheckSum Checksum of E2P.
Feature
switch
Audio
Prescaler
127 (default value not to change, vary source to
source).
OSD
Language
To change OSD language English + Arabic or
French.
Ecovision To make ON/Off Eco vision feature.
Energy Meter To make ON/Off Eco vision feature.
Back light
To make ON/OFF backlight parameter in User
menu.
To Next Page
Loading...