Videocon DDB DLX - Software Installation Procedure; USB Installation (Standby Mode)

SW INSTALLATION PROCEDURE
The ATV SW installation in DDB DLX chassis can be done with USB in three ways.
1.) SW Installation through USB in Set stand by condition.
2.) SW Installation through USB in Set ON condition.
3.) SW Installation through MST Tool.
36
1
Copy the SW (.bin) file in USB to root
directory.
2
Rename the SW
file name as “videocon.bin
”
for Videocon brand TV and “sansui.bin for
SANSUI brand TV.
3
Keep the TV set in Power OFF condition.
4
Plug
in the USB drive in USB port of the TV.
5
Turn ON the Mains power of
TV set.
6
Now
after a few sec., RED LED indicator of
TV will start blinking, indicating the SW is
loading.
7
After a few sec. LED blinking will stop
and
SW loading is finished. Then follow below
steps.
A.) SW INSTALLATION THROUGH USB IN STAND BY CONDITION: -