Videofied KF 240 User Manual

KF 240/641/742 4-BUTTONS REMOTE KEYFOB
INSTALLATION SHEET
DOC. - REF. 217-KF
EDITION DATE : NOVEMBER 2016
1
Operation
Press briefly and release the corresponding button to arm
(full arming or partial arming) or disarm.
The first beep confirms the button has been pressed. Two beeps
confirm that the panel has received the command. If the panel has
not received the command, only one beep is emitted by the keyfob.
A red double flash confirm the system full or partial arming. A green
double flash confirms disarming.
To trigger an alert, press and hold one of the partial arming keys for
2 seconds.
> Note : This keyfob is powered by a CR3032 lithium battery with a
5-year battery life.
Commands
Full
Arming
Partial
arming 1
Siren alert after
holding for 2 seconds
Disarming
Partial
arming 2
Silent alert after
holding for 2 seconds
Press and hold ___ & __
simultaneously for 5 seconds
The keyfob emits delay beeps when the system is armed. You can determine if a door contact is still open.
If a device is detecting while the panel is arming, the keyfob emits a 4-second long beep.
You do not need to wait for the beeps to stop to leave the premises. The beeps will automatically stop after the configured exit delay.
Programming
Enable the device recording mode on the panel, the keypad
will display “PRESS PROGRAM BUTTON OF DEVICE”.
Press and hold the keyfob & keys simultaneously.
When releasing, the keyfob emits a beep and a flash every
second then the keyfob is recorded by the panel.
If the keyfob is not recorded, confirm that the keypad is
displaying:
then press and hold the keyfob & keys again (by
strongly pressing the buttons).
PRESS PROGRAM
BUTTON OF DEVICE

Videofied KF 240 Specifications

General

Brand	Videofied
Model	KF 240
Category	Remote Control
Language	English

Summary

Programming

Keyfob Recording Process

Enable recording mode, press and hold keyfob & keys simultaneously. Keyfob beeps and flashes upon release.

Troubleshooting Keyfob Recording

If not recorded, confirm keypad display and press & keys again to re-record.

Keyfob Functions and Operation

Arming and Disarming Commands

Press buttons briefly to arm system (full/partial) or disarm. Beeps and flashes confirm status.

Alert and Notification

Hold partial arming keys for 2 seconds to trigger siren or silent alerts. Beeps indicate exit delay.

Safety and Regulatory Information

Battery Safety Precautions

Remove battery before maintenance. Risk of explosion if replaced incorrectly. Observe polarity and dispose properly.

FCC Part 15.21 Compliance

Changes to equipment not approved by RSI Video Technologies may void FCC authorization.

FCC Part 15.105 Class B Compliance

Equipment tested to comply with Class B limits for residential interference protection.

RF Radiation Exposure Limits

Complies with FCC limits for uncontrolled environments, requiring 20 cm separation from body.

Technical Specifications

Electrical Properties

Details panel compatibility, power, battery, RF technology, frequency, and security.

Physical Properties

Specifies material, dimensions, weight, operating temperature, and humidity.

Certifications and Compliance

Lists certifications like CE, FCC, IC, and Australian C-Tick for various frequency bands.